0

Couple of Initial Issues

Larry Neblett

October 17, 2020 16:44

None

Follow

Having gone thru the initial setup wizard, the date/time setting was made using the us.pool.ntp.org server and -6 for central US time with daylight savings enabled. Following the requisite server reboot following the completion of the wizard and checking the time following same it shows - 

But it is AM not PM It would be nice to have a button to force a sync with the server rather than having to reboot. 

 

However, when look at the system config from the  dashboard the correct time is reported - 

• Facebook
• Twitter
• LinkedIn

3 comments

• 0
  
  Larry Neblett October 17, 2020 17:39

  In addition to the above, after having updated the F/W to 37.1.0.11, the time now shows:

  

  But from the Dashboard Info screen it shows - 

  

• 0
  
  Pixy Tse October 26, 2020 05:17

  Hi Larry, may I know did you try to perform a hardware reset after the firmware upgrade?

  The hardware reset method: When the PBX is power up and steady for 5 mins. Press the reset button for more than 5 seconds but less than 10 seconds, then release the button. Then configure it again from scratch.
• 0
  
  Larry Neblett October 26, 2020 12:00

  Did not need to do a reset, by the next morning it was reporting the correct time in both areas,. What I did not understand, was why the device would report the correct time in the dashboard, but not the time setting area.