Scenario:
TE200 connected 2 E1 lines, TE200 connected to Yeastar PBX via a sip trunk.
Assume that the PBX has extension numbers 1000-1059, and two E1 lines each have 30 numbers. You want to use the 30 numbers of E1trunk1 to receive&make calls from 1000-1029, and you want to use the 30 numbers of E1trunk2 to receive&make calls from 1030-1059.
Configuration:
First, Connect this TE200 with Yeastar PBX via a sip trunk. Refer to below guide to connect them.
Second, Configure specific extensions to call out from specific E1 lines
Configuration in Yeastar PBX outbound route:
Yeastar PBX side create an outbound route to make calls to TE200, as shown below.
Configuration in TE200 route list: use the inbound caller pattern to match the extensions number to catch the route to make calls.
For extension 1000-1029 to make outbound calls via E1 trunk1, as shown below 
For extension 1030-1059 to make outbound calls via E1 trunk2, as shown below
In short, use the inbound caller id pattern to match different TE routes to use accordingly E1 line to make calls.
PS: If the same extension wants to select different E1 lines for outgoing calls, you can dial different prefix numbers to match different routes and use different E1 lines for outgoing calls.
Refer to below guide
Third, Configure specific extensions to receive calls from specific E1 lines
For inbound calls from E1 trunk1 to extension 1000-1029,
Route in TE200, use outbound dail pattern to route the call to different destination. As shown below.
inbound route in P560 side to match the DID number format to route the calls to corresponding extensions.
For inbound calls from E1 trunk2 to extension 1030-1059,
route in TE200, use outbound dail pattern to route the call to different destination. As shown below.
inbound route in P560 side to match the DID number format to route the calls to corresponding extensions.
0 Comments