How to Send Email to SMS on S-Series

Introduction

Email to SMS is a feature that allows users to send SMS to mobile phone number via email. When users would like to send a SMS, they just need to send an email to the Yeastar S-Series system email address, with the destination mobile phone number as the email subject. The system will then receive the email and forward the email to the GSM/3G port, so that the email can be sent out through SMS to the expected destinations.

This guide introduces how to configure Email to SMS on Yeastar S-Series VoIP PBX. 

Also, we have a video guide: How to use Email to SMS on Yeastar Devices (Video)

 

Before You Start

Before you start to use Email to SMS, please check the following:

  • Install GSM/3G module on the device.
  • Insert SIM card on the GSM/3G module.
  • Check the trunk status and make sure that the GSM/3G trunk is ready.
  • Set a system email on S-Series PBX (Settings > System > Email). The system email is used to forward the received email to the destination phone number.

Configuring Email to SMS

  1. Go to the “Setting > System > Email”, set a system email and click “Test”.

  2. If the system says “Test Successfully”, it means the email address could send and receive emails on the PBX.


  3. Go to the “Setting > PBX > Call Feature > SMS” page, configure “Email to SMS” settings.

  • Country Code: choose your country code.
  • Email Checking Interval: set the interval, default is 60 seconds.
  • Access Code: optional setting. The access code is used to verify the email subject received. If you set the access code, the email subject must contain the code.

Sending Email to SMS

Note: Limit your sending speed to 1 SMS per 10 seconds for 1 port when using EmailtoSMS.

Sending Email to SMS, the email subject format is:

port:[port];num:[number];code:[code];

  Note
     For S100 and S300, you need specify the GSM/3G port is on which expansion board.
     For example, "port:2_1", means Expansion board 2 port 1 is GSM/3G port.

Assume the Yeastar S-Series system email is spbx@yeastar.com. We show you how to send Email to SMS in different ways.

  • Send Email to SMS without Access Code through default GSM/3G Port
    Email Subject: num:[number];
    As the following figure shows, the email will be sent to the number "15880290900" through an available GSM trunk.


  • Send Email to SMS without Access Code through a specific GSM/3G Port
    Email Subject: port:[port];num:[number];
    As the following figure shows, the email will be sent to the number "15880290900" through GSM/3G trunk 5.


  • Send Email to SMS with Access Code through the Default GSM/3G Port
    Email Subject: num:[number];code:[code];
    As the following figure shows, the email will be sent to the number "15880290900" through an available GSM/3G trunk.


  • Send Email to SMS with Access Code through a Specific GSM/3G Port
    Email Subject: port:[port];num:[number];code:[code];
    As the following figure shows, the email will be sent to the number "15880290900" through GSM/3G trunk 5.


Have more questions? Submit a request

3 Comments

  • 0
    Avatar

    Hello,

     

    How to put more than one recipient number in the subject box??

  • 0
    Avatar

    Hello Colleagues.

    How to send USSD using S-series PBX and receive USSD answer?

  • 1
    Avatar

    hola, el envio de sms mendiante correo, se debe hacer desde una plataforma especifica?

Please sign in to leave a comment.