This guide introduces how to provision Htek IP phones with Yeastar S-Series VoIP PBX. You have two ways to configure the Htek phone:
Note: Before provisioning the phones, you must reset the phones to factory defaults in case that the phones have residual settings of a previous configuration.
Supported Phone Models
- Htek UC Series: 802, 803, 804, 840, 842, 806, 860, 862, 902, 903, 923, 924, 926
Provisioning Htek Phones via PnP
- Connect the phone to the same network with Yeastar S-Series PBX. The phone will send a PnP request to the PBX when booting up. By default, PnP is activated on the phone.
- Log in Yeastar S-Series Web interface, go to “Auto Provisioning” App. Click “Scan”, all the phones in the local network will show up on the page.
- Search the phone by MAC address or IP address, and click “edit”.
- Choose the phone Model, active a line and assign an extension for the phone. You can also configure keys, features, preferences and codec for the phone.
- Click “Save”.
- The system prompts you to reboot the phone, click “OK”. The phone will reboot and configure automatically.
Provisioning Htek Phones via DHCP
- Connect the phone to the same network with Yeastar S-Series PBX.
- Disable local DHCP server in your local network, e.g. disable DHCP server on Linksys router.
- Enable DHCP server on Yeastar S-Series and configure the DHCP server settings according to your local network. (Settings > System > Security > Service)
- Go to “Auto Provisioning” App. Click “Scan”, all the phones in the local network will show up on the page.
- Search the phone by MAC address or IP address, and click “edit”.
- Choose the phone Model, active a line and assign an extension for the phone. You can also configure keys, features, preferences and codec for the phone.
- Click “Save”.
- The system prompts you to reboot the phone, click “OK”. The phone will reboot and configure automatically.
0 Comments