
phb
- Total activity 22
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 8
Posts
Recent activity by phb Sort by recent activity-
P550 37.7.0.51 WebUI unresponsive / Cannot delete 8000+ Blocked IPs
I nearly was unable to login into the WebUI of the PBX. Several browsers complained about site does not respond after the entry page was loaded. After wating patientely for 10 minutes I was able to...
-
change voicemail to play only greeting, set leaving a message disabled. Possible?
While I dont think this is doable on a per extension base, I could imagine that there is a way to accomplish this for the whole PBX system (S or P series). Is there a way to do this?
-
Linkus External SIP Port (wihout LCS) S Series vs P series
Hello, in the P Series, I am able to specify a Linkus SIP port like 6023 for external usage. I would then use the NAT redirect feature of the router to redirect 6023 to the internal port 5060. That...
-
S-Series 65.15.0.18: madplay missing?
I tried to set MOH to a web url. However. Silence. In the system log /ysdisk/ysapps/pbxcenter/var/lib/asterisk/sounds/moh/teststream.sh: line 2: /sbin/madplay: not found Indeed. there is no madplay...
-
res_timing_timerfd.c:167 timerfd_timer_ack: Expected to acknowledge 1 ticks but got 2 instead
I have a problem with a new S50 pbx: After about 6 to 10 hours incoming and outgoing calls are not working. Trunk is ISDN. I enabled the asterisk + ISDN debug. When I start the asterisk debug, abou...
-
ISDN strange/wrong incoming Number?
I try to setup a S50 with the 2Bri module. One of the BRI as a trunk. I can make outgoing calls. I also can receive calls if I accept any DID. But when I create an incoming rule to filter by DID th...
-
Linkus Provisioning (no cloud) wrong IP Address for local network in Barcode
I setup a new S50 PBX. Setup Linkus without Cloud connector. Generate a welcome Mail. Scan barcode with mobile. When I look afterward in the addresses povisioned for the Linkus client I see the cor...
-
Linkus client difficult to use on Android client with screens like 1:1, 3:2 etc:
When I launch the Linkus Client on a Unihertz Titan or Titan Pocket or on a Samsung S7 Tablet it is hard or even impossible to use: On the Unihertz phones the lower part of the screen is clipped, b...