Mandy Wang
- Total activity 211
- Last activity
- Member since
- Following 0 users
- Followed by 4 users
- Votes 2
- Subscriptions 106
Activity overview
Latest activity by Mandy Wang-
Mandy Wang created an article,
How to Use DNIS
Introduction Dialed Number Identification Service (DNIS) is a feature of Yeastar IPPBX, which could be used to determine which trunk was dialed by the customer. With this feature enabled, the calle...
-
Mandy Wang created an article,
E1 Basic Installation Guide
E1 Cable Please confirm the line pinout of cross-over E1 cable at first with the following figures. Web Configuration Step 1. Check the E1 trunk status following page “PBX Monitor> Trunks”. ...
-
Mandy Wang created an article,
Seizing PSTN Line Faster
There is a phenomenon that when making outgoing call through PSTN trunk on Yeastar S-Series IPPBX and it takes about several seconds before the call is established to the destination number (e.g. M...
-
Mandy Wang created an article,
Provision Phonebook by Yeastar S-Series IPPBX
With this guide, you can add contacts on or upload a phonebook to Yeastar S-Series IPPBX. So that the phonebook will be obtained by the phones during the phone provisioning process. Note: the preco...
-
Mandy Wang created an article,
How to Capture PRI logs in S-series VoIP PBX
This guide introduces how to capture PRI logs with Putty for Yeastar S-series VOIP PBX. Please follow the steps below to capture PRI logs. Download Putty Step 1. Login via SSH. 1> Login S Series...
-
Mandy Wang created an article,
How to Remove Prefix + for Incoming Caller ID
Introduction By default, you cannot remove prefix + for incoming caller ID on Yeastar U-Series and Yeastar N-Series analog phone system. This article introduces how to remove prefix + for incomin...
-
Mandy Wang created an article,
How to Use Monitor Feature
Yeastar S series allows extension to monitor/barge in the conversation. Once this feature is enabled, the extension would have the ability to monitor/barge in calls using the feature codes for each...
-
Mandy Wang created an article,
How to Monitor the Time Condition State
Introduction This passage we will show you how to monitor the Time Condition state by the IP Phone BLF button with Yeastar S-Series VoIP PBX. With the following settings, you can accomplish the goa...
-
Mandy Wang created an article,
Using LDAP on Fanvil Phones
In this example, we will demonstrate how to configure and use LDAP phonebook using a Fanvil X4. Configuring LDAP LDAP Configuration Example Using LDAP Phonebook Configuring LDAP Log in the Fanv...
-
Mandy Wang created an article,
How to Customize Your Voicemail Greetings
Introduction The default voicemail greetings in S-Series VOIP PBX are fine but it’s rather bland and quite boring. You can customize your own voicemail greetings. You have two ways to change your v...