
Graham Aker
- Total activity 43
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 20
Activity overview
Latest activity by Graham Aker-
Graham Aker commented,
Here are some common causes for the SIP extension registration. Hope it will help. https://support.yeastar.com/hc/en-us/articles/360008993173-Common-causes-for-SIP-Extension-Registration-Failures
-
Graham Aker commented,
The premise for the sip trunk connection is the network connection. You can check whether the network between TA device and fusionpbx is available first.
-
Graham Aker commented,
You might consult with Yeastar Support to reset the password by console cable. Here is the entrance: https://support.yeastar.com
-
Graham Aker commented,
If the analog phone could work with the fxo line normally, it might be the issue related to the signalling detection of the device you use. Which model of Yeastar device you are using now? And in c...
-
Graham Aker commented,
I tried check my S20 web interface, there is not the option like you mentioned for the beep before paging. You might consult with Yeastar support to find out if there is anyway to achieve that.
-
Graham Aker commented,
I found the related document on BRI, you might try to get the log and send to Yeastar Support. Hope it will helpful to you. https://support.yeastar.com/hc/en-us/articles/216953968-How-to-Enable-PRI...
-
Graham Aker commented,
As Riddhe mentioned there is upgrade option web which could also as downgrade. Regarding to the oldest firmware, I can not find it on offiical web site. You may consult with Yeastar Support for the...
-
Graham Aker commented,
You may try to reset the device to factory. This is the instruction of the reset operation in Yeastar knowledge base. https://support.yeastar.com/hc/en-us/articles/115015984887-How-to-Perform-Reset
-
Graham Aker commented,
As the previous description of the issue, the from field for first packet is wrong. It seems that related to the wrong IP 172.17.2.15 in from field. When you use NAT, the IP address may change to W...
-
Graham Aker commented,
It seems that yeastar device regard the 1100 as the internal extension locally. You may change the DID number on S300:- inbound DID Pattern: 981000-981299 And don't discard the 98 on cucm side.