0

MyPBX SOHO 02 modules?

Burrel Burnett

September 24, 2018 16:30

None

Follow

I am attempting to use a MyPBX SOHO with 4 analog phone lines. I have installed two 02 modules. When I plug in the working lines to the ports and power u up I get no port lights. I also see no physical trunks in the management software. All advice and opinions will be greatly appreciated!

• Facebook
• Twitter
• LinkedIn

2 comments

• 0
  
  Oscar Colka September 25, 2018 05:24

  Burrel,

  First of all, the LED light should in RED blinking after you install O2 module. Once you plug in PSTN line, it should light in RED steadly. 

  Step1, Try reinstall the O2 modules, try from install one O2 module and see if you can have it work.

  If reinstall the modules without luck,

  Step 2, Backup your configurations first then remove the O2 modules and reset the device to factory default. After that, re-install the O2 modules and see if you could have it works. 

• 0
  
  Burrel Burnett September 25, 2018 09:33

  Thank you!