Hello guys i have problem when i change port SIP (5060) to custom port (ex:5160,5170,6080) , the extension registered but no audio from 2 way, and when i revert to default , everything ok , no issue.
please help me to solved this problem.
thx guys
fyi : PBX : S20
pacp : https://goo.gl/gF9ZBd > issue
pacp: https://goo.gl/XzfQc1> ok
for topology > router HG824H > SWITCH > S20 & T410
sip alg > checklist
dmz > 192.168.100.20 (pbx)
Please try setup below settings and see if this would help:
1. Enable NAT for remote extension on extenion page;
2. Setup NAT settings on SIP settings page. See below screenshot:
If not, please capture the pcap logs and post here.
Note: If you setup DMZ for your PBX, please pay attention to the security of your PBX. You must setup proper security rules to make sure your system is secure engough.
I've tried the above way over and over again by replacing its port as well , but still not work.
Can you post your new pcap logs after you make the changes?
Logs you post just now is unreadable, try use dropbox and post a download link for the logs.
i edit my post above
Same logs? Check if you upload the corect logs after you make the changes.
https://goo.gl/dwbKXH , this the newest
for dmz , when i disable it the ext cant make a call and notif " no route destination "
I checked the logs, but it doens't include complete logs for one SIP call.
Please Click the Start button before you make the call, then make the call, after you finish the call, click stop button.
I've been following a step like you
Still not full logs:
hemm whyy , my wireshark show full log
Can you try if you can filter any VoIP calls in your pcap logs?
Microsoft Teams Integration
Hikvision Intercom Integration
ISDN Switch-off Migration
All materials to evaluate Yeastar as a PBX vendor on products, solutions, partner program, support, learning resources, etc.
