0

Yeastar S300: AMI closes connection

Steven

February 28, 2018 12:27

None

Follow

Hello,

I am losing every AMI connection after 30 seconds.

I am using PuTTY to connect to AMI but after 30 seconds  the connection is lost and this error appears:

"Connection closed by remote host"

It is regardless of whether I am logged in or not.
My manager.conf looks like:

[general]
enabled = yes
webenabled = no
port = 5038
bindaddr = 0.0.0.0
displayconnects = no

[Developer]
secret = Developer
read = system,call,log,verbose,command,agent,user,config,originate,cdr
write = system,call,log,verbose,command,agent,user,config,originate,reporting
deny = 0.0.0.0/0.0.0.0
permit = 127.0.0.1/255.255.255.255
permit = 192.168.0.0/255.255.0.0
[cliuser]
...

The S300:

Yeastar S300

 

Serial Number:

369464865039

 

Hardware Version:

V1.30 0000-0000

 

Firmware Version:

30.6.0.20

 

System Time:

2018-02-28 13:25:56 Wed

 

Uptime:

00:25:24

 

Extensions/Max Extensions:

110/400

 

Any suggestions?

• Facebook
• Twitter
• LinkedIn

2 comments

• 0
  
  Oscar Colka March 01, 2018 06:12

  I tested this with S50 firmware version 30.6.0.20 but didn't experience the same issue. I would suggest you to test with another PBX or another environment (latop, network and so on) to check where would be the issue.

   

  

• 0
  
  bill March 09, 2018 23:00

  Sounds amazing similar to what we experienced when routing SIP calls to an S Series behind a seriously under powered residential standard variety DSL gateway / router.  Incoming calls would drop at 30 to 32 seconds duration every time.  replaced modem with Microtik router and  issue resolved.  Not sure if this is a router processor issue like we had but it sounds very familiar.