0

[N412] How to speed up internal group call?

Volker

February 04, 2018 15:41

None

Follow

Hi,

I run three internal groups and the doorbell is dialing them. We also use the groups manually. I defined 301, 302 and 303 as group numbers. But it looks like the system always waits for another 5 seconds upon I dialed the last number. Maybe to find out if I like to ring outside?

I found no way to define the group or outgoing rule in a way that prevents the system from waiting for other digits. Is there a way to define ring roups so that they do not wait for dialing more numbers? Eg I dial 301 and it directly starts to ring for the devices? Or *301? How to? Or can I set-up in a way it needs a 0 for dialing out? Does it then dial directly? Any advise or tutorial for such setup available?

• Facebook
• Twitter
• LinkedIn

2 comments

• 0
  
  Oscar Colka February 05, 2018 07:20

  Try adjust the interdigit timeout to a shorter number and see if that help. Note if you chang that value, it may affect your outgoing dialing timeout as well.

  Another way is after you finish dialing, please dial key # to inditify you have finish dialing.

  Gook luck.

  

• 0
  
  Volker February 06, 2018 18:07

  The sharp key was very helpful, thanks! I re-programmed the doorbell and now we have 5 seconds less delay upon it was pressed. Great! I also reduced the Interdigit Timeout to 4 seconds. Lets see how it works...