Hi Sir/Ma'am,
Our speed dial feature in MyPBX U100 doesn't seem to work even after following instructions from you PDF manual.
Say I want to speed dial a local emergency number 991 which goes through prefix of 0 (any free FXO trunk), what should I do?
Furthermore, in reference to screenshot attached: is "source number" the extension number or the telephone number assigned to an FXO port? I tried both and it doesn't seem to work.
Thank you for your help.
Sincerely,
Sujirou
Sujirou,
See below screenshot:
With the example, you can dial *991 then the U100 will dial out 099189789, this means *99 + source number will be replaced with the destination number when you dial out.
For your case, you may not need to use speed dial feature. I think you may need to setup proper outbound route to support your request.
Hi Oscar,
Thank you for your response Sir. It was certainly most helpful in letting me figure out how to allow direct dial to emergency our number number. It is most appreciated.
Sincerely,
Sujirou
Thank you, Oscar! Your help is greatly appreciated, info is on point.
Microsoft Teams Integration
Hikvision Intercom Integration
ISDN Switch-off Migration
All materials to evaluate Yeastar as a PBX vendor on products, solutions, partner program, support, learning resources, etc.
