0

How to connect Yeastar TG400 with UCM 6108

David-John van der Merwe

October 03, 2017 16:28

None

Follow

I'm trying to get our BRI lines connected to the UCM 6108 through the Yeastar TG400. I have read all the how to's but I'm still not getting it to work.

Steps:

VoIP Trunk on the TG400 is created as service provider and status shows that it's good.

Bri_2_Sip route - call comes in correct, send call to trunk created in previous step

Created a peer sip trunk on the UCM side.

Create inbound route on UCM side for the peer sip trunk created in previous trunk.

Test call shows on the call logs on the Yeastar TG400 it shows that the correct source trunk and destination trunk was reached but the status shows FAILED. 

 

Any help would be greatly appreciated.

 

Thanks

David-John

• Facebook
• Twitter
• LinkedIn

5 comments

• 0
  
  Oscar Colka October 09, 2017 06:20

  David, I am a little bit confused. Do you mean TG400 as TB400?

  If not, can you post a picture and show how you connect Yeastar devices and UCM?

• 0
  
  David-John van der Merwe October 09, 2017 06:51

  Sorry, I meant TB400. I did figure it out with a lot of effort. How can one do a dial pattern like 22XX as it only accepts numbers. Our ISDN range is from 2200 - 2239 and I want to cover the entire range.

   

  Thanks

  David-John

• 0
  
  Oscar Colka October 09, 2017 07:27

  See if below screenshot is what you want:

  

  

• 0
  
  David-John van der Merwe October 09, 2017 07:56

  Exactly but if you specify 22XX and associated number then you aren't allowed to put in the XX that covers the range.

• 0
  
  David-John van der Merwe October 09, 2017 08:45

  No worries, just leave DID associated number blank. Put in a hotline number and choose that number as pattern for you incoming route on your server.