Hello,
I come to ask you for help for the
interconnection of mpbx Yeastar
U100 and a CME 3945 CME. The users
of the two systems are able to call each
other but CME users can not call the PSTN
numbers Through the Yeastar U100 mpx despite
the creation of the voip dialpeer. The CME is
recently installed and must use the Yeastar mpbx
as gateway to the anological lines.
Your helpers will be very useful to me. Thank you
in advance !
4 comments
-
Oscar Colka Check if below article help:
-
Mamoud Tom Daou Hello,
I thank you for having reacted so quickly.
The link you sent me helped me a lot because I can make calls now. But I have two concerns:
1- To call the anological lines, I must first dial the number of the extension that allows me to be connected to the PSTN and composed the number of the recipient.
2- When I call, the recipient sees my number with the first two digits in less.
Big thanks!!! -
Oscar Colka Which mode did you choose to interconnet your CME and MyPBX?
Did you try connect through VoIP P2P mode? Please check the article and folow the VoIP P2P mode. Through this mode, you will not need to call the extension number first before you can dial out.
-
Mamoud Tom Daou Hello,
If I use the VoIP p2p mode as you advised me, I can not make any calls via the pstn. On the other hand, with the DISA, I send calls through the pstn but I have to connect to the extension by dialing 2001 which is an extension created on the Yeastar U100 which is connected to the outgoing route and to DISA . I would like to make calls without connecting to the 2001 extension to make calls via the PSTN trunk.
BIG THANKS !