Hello
I got TB400 , works well with VoIP but I get some troubles with BRI
I try to change loadzone for from us to fr is ok
but ami : span=2,1,0,ccs,ami
to
span=2,1,0,ccs,hdb3
I can do , afer reboot ami configuration is restored
is there a solution to keep my modification after reboot
Thank
Vass, do you have any problem if setup the coding as ami?
As I know from my Yeastar support representative, Yeastar TB series support for ami coding only but not hdb3, so even you can keep the modification after reboot, the setting will not take effect.
Hello,
Yes , I found workaround for set ndb3 by it doesn not work :-) by editing yadahdi.conf
Something strange cause when I set pri_net my line is up with other equipment
I got SAMBE ..
Any idea ?
Sorry my post is not clear
If I use bri_cpe into TB400 site ans other equipment is on NT mode I got SAMBE in each side
Can be timing issue ?
Vass, is it configured as "point to point" or "point to multiple point"?
If it is "point to point" then it is normal both side got SAMBE
The process of data link layer should be:
Hello
Is is point to point ...
Can I change timing source in the system.conf ?
I tried by editing /persistance/etc/ysdahdi , /persistance/etc/dahdi but in the reboot the yeastrar generate default config
Vass, what I learned from Yeastar team is that, if TB is configured as CPE side, then it will try get timing from the BRI line by default, if it is configured as NET side, it will try generate timing for the CPE.
Seems there is not way to change the timing source by edit system.conf.
Which setting did you try modified?
What is the problem? The line couldn't up? Or calls can't be made through the lines?
Microsoft Teams Integration
Hikvision Intercom Integration
ISDN Switch-off Migration
All materials to evaluate Yeastar as a PBX vendor on products, solutions, partner program, support, learning resources, etc.
